|
Shotblast Southwest Inc. provides the proper surface profiles.
Finer profiles produced by finer
shot are ideal for retention on new thin-coat epoxy or urethane film, usually applied to 8-10 mil. thickness
Use of
coarse steel shot produces the deeper profile usually recommended for topping and overlaymment coatings.
FEATURES
AND BENEFITS
-A dry process permitting immediate installation of coatings with no moisture to affect coating adhesion.
-NO fumes.
-NO pollution or dust.
-Little or no interference to your operation.
-Ideal surface
texture for mechanical bonding of coatings.
-Etching of slippery surface where coatings are not specified.
-This
system will remove most coatings including elastomeric urethane.
The shotblasting system incorporates the high
performance airless centrifugal wheel for propelling blast media in a controlled pattern and direction. Metal abrasive thrown
by the rapidly rotating blast wheel scours the concrete surface and rebounds aling with removed contaminants into a recovery
chamber. Pulverized abrasive, dust and contaminants are removed by a seperate dust collector. Very little abrasive is lost
and the usable media is returned to the storage hopper for recirculation by the blast wheel.
| Left side shows old coating |
|
| Right side shows concrete after shotblasting |
|
